CCNA3 Skill Final Practice Instruction

Tasks (minimum 80%)
·        Configure VTP with S0 as server and S1, S2 as clients, with domain “CCNA” password “cisco”. Create vlan 10 and 20 in S0. Configure port channels LACP active (ether channels) and trunks using the above table.
·        Configure routers R0 and R2 using multi-area OSPF with designated area ID shown in the figure. Use OSPF process ID as 1.
·        Configure g0/2 as layer 3 port and assign ip as shown in the above table. Configure g0/1 encapsulation dot1q and trunk. Create vlans 1, 10, 20 and assign ip addresses on vlan interfaces 1, 10, 20 according to the above table. Configure ip routing in MLS. Configure OSPF with designated area ID shown in the figure. Use OSPF process ID as 1.
·        Add a default route in R0 to S0/1/1 and advertise in OSPF.
·        Use Serial clock rate 64000 in all cases.
·        Configure all PCs.

Test (Min 5 successful)

1.      Ping from PC0 to PC1
2.      Ping from PC0 to PC2
3.      Ping from PC0 to web server
4.      Ping from PC1 to web server
5.      Ping from PC2 to web server
6.      Ping from PC2 to S2.